e4035ede

8.1.6. Removal and MKPP installation

Removal
PERFORMANCE ORDER
1. Remove a cowl.
2. Lower pressure in fuel system.
3. Disconnect a wire of the minus plug of the accumulator.
4. If the car is equipped with system a cruise control, disconnect a wire from the block of the working mechanism of system and remove the block (bolts of the electronic block of system a cruise control are specified by shooters).
5. Remove the accumulator and the shelf of the accumulator.
6. Remove an airintaking pipe of the air filter.
7. Uncover a jellied mouth of the fuel tank and disconnect the fuel tubes connecting the engine to a body.
8. Remove the fuel filter and an arm of the filter.
9. Remove a starter.
10. Disconnect a grounding wire (it is specified by an arrow) from the transmission.
11. Unscrew cylinder bolts (the left shooters) of the hydraulic drive of coupling from the transmission. Do not disconnect a tube from the cylinder. Unscrew bolts of container with liquid of the hydraulic drive of coupling (the right shooters) and remove an arm of tubes.
12. Disconnect a rope of the throttle valve and a rope of system a cruise control from the lever mechanism of a throttle
13. Disconnect all hoses and wires.
14. Remove the cooling fans. Merge cooling liquid, remove a radiator, remove all hoses of cooling liquid and hoses of a heating system.
15. Disconnect gear shifting ropes.
16. Unscrew the top assembly bolts of the transmission.
17. Remove an arm of a final collector.
18. Weaken bolts of forward wheels. Lift and fix the car on support. Remove forward wheels.
19. Disconnect exhaust pipes from final collectors and from the catalytic converter. Remove forward section of an exhaust pipe (it is specified by shooters).
20. Remove protective guards.
21. Merge engine oil.
22. Take off driving belts.
23. Merge transmission oil.
24. Remove half shafts.
25. Disconnect steering transfer with the amplifier from a suspension bracket.
26. Unscrew four bolts of an arm of the stabilizer of stability.
27. Tie up steering transfer to a body and unscrew bolts (are specified by shooters). Steering transfer should not prevent removal of the transmission.
28. In six-cylinder engines unscrew the bolts fixing the shock-absorber to the transmission (are specified by shooters).
29. Unscrew bolts of a forward support of the engine.
30. Remove the left support of the engine and an arm of a support.
31. Disconnect a back support of the engine from the transmission.
32. Unscrew suspension bracket cross-piece bolts.
33. Establish a jack under the transmission.
34. Remove a stiffening rib in the left part of the transmission.
35. Unscrew bolts of an arm (A), remove the right stiffening rib (V) and a trailer disk (C) – the 4-cylinder engine.
36. Bolts of a trailer disk (are specified by shooters) – 6-cylinder engines.
37. Accurately lower the transmission.

Installation

Installation of the transmission is carried out upside-down removals.