9.2.7. Removal of air from a power steering contour
It is necessary to remove air from a wheel hydraulic actuator at any dismantling of the highway, irrespective of those measures against air hit which were taken.
| PERFORMANCE ORDER |
| 1. Establish wheels in the provision of driving on a straight line and check liquid level, if necessary restore, having added to Cold tag on the tank probe. |
| 2. Start the engine and after work on bystry single to the engine course check liquid level again, if necessary restore, having added to Cold tag on the tank probe. |
| 3. Turn a wheel here and there against the stop, at the same time do not allow strong impact with limiters, hold a wheel at the end of each course. Air at the same time is removed from a contour of the hydraulic booster. At implementation of this procedure you watch liquid level. |
| 4. Establish wheels in the provision of driving on a straight line and several minutes later stop the engine. |
| 5. Again check the liquid level which has to be on the heated-up engine about the mark Hot in the tank probe. If necessary add.
|
|
