| 1. Clean the surfaces of the block of cylinders and the balancing device, establish laying.
|
| 2. Install the first piston in the top dead point.
|
| 3. Combine tags (deepening) on shaft with the cuts corresponding to them in a casing of shaft.
|
|
4. Install the balancing device on the block and insert bolts. Tighten bolts till the required inhaling moment in the specified sequence.
|
| 5. Measure trailer gaps of shaft by means of the special measuring instrument. If gaps exceed the most admissible limits, address the expert.
|
|
6. Measure a district gap of the tooth gearing of a shaft of N1 in four various provisions (1 – a gear wheel of a bent shaft, 2 – N1 shaft gear wheel). |
|
7. Combine a tag And N1 shaft with a cut in a casing and measure a district gap (1 – the top half of a casing, 2 – N1 shaft). |
|
8. Combine a tag In N1 shaft with a cut in a casing and measure a district gap. |
| 9. If the free wheeling of a shaft exceeds admissible limits, adjust its size by means of adjusting laying.
|
