| 1. Pit pressure in fuel system.
|
| 2. Disconnect a wire of the minus plug of the accumulator.
|
| 3. Remove the accumulator and an arm of the accumulator.
|
| 4. Remove an engine cowl.
|
| 5. Remove the air filter.
|
| 6. Lift and fix the car. Merge cooling liquid and engine oil. Take off driving belts.
|
|
|
7. Mark both ends and disconnect vacuum hoses, hoses of cooling liquid and final gases. Disconnect wires and fuel tubes. To mark wires use an insulating tape. |
| 8. Remove a broad tank of the cooling system and a tank of windscreen washers.
|
| 9. Remove radiator fans, a casing of fans and a radiator.
|
| 10. Disconnect heater hoses.
|
| 11. Disconnect the fuel tubes connecting the engine to a body.
|
| 12. Disconnect a rope of a butterfly valve, a rope of the throttle valve of the transmission and a rope of the sensor of a speedometer from the engine.
|
| 13. Disconnect holders of a plait of wires of the engine.
|
| 14. Unscrew assembly bolts of the pump of system of strengthening of a wheel. Whenever possible shift the pump aside without disconnecting from it hoses. If necessary remove the pump.
|
|
|
15. Remove the compressor of the air conditioner and shift it aside. Do not disconnect hoses from the compressor.
|
| 16. Disconnect an exhaust pipe(s) from a collector(s).
|
|
|
17. In four-cylinder engines remove an oil filter, disconnect hoses from the oil heater and remove the oil heater (shooter).
|
| 18. Fix a chain on the hooks intended for a raising of the engine and connect a chain to the elevator. |
|
|
19. Remove the leading axis (A) from passenger sitting, unscrew a through bolt of a support of the engine (V) and remove a back arm of the engine (C). |
|
|
20. Unscrew the bolt fixing a forward support of the engine to a body(bodies) if you remove the engine together with the transmission, remove the shock-absorber of the engine (B). |
| 21. In models with the automatic transmission remove the dustproof screen of the hydrotransformer, remove clamps of the hydrotransformer and slightly press the hydrotransformer into a transmission casing. |
| 22. If you remove only the engine, unscrew bolts and disconnect the transmission. |
| 23. Check that nothing prevented removal of the engine. |
| 24. Establish a jack under the transmission. Unscrew bolts from engine support. |
|
|
25. Slowly lift the engine on the elevator (in the drawing the 4-cylinder engine together with the transmission is shown). |
| 26. Lower the engine on specially equipped rack or on a workshop floor. |
