6.6. Removal and installation of the fuel pump
The fuel pump – type A
|
1. Cover
2. Wire of the fuel pump and sensor
3. Protection cover
4. Plate
5. Fuel hose
6. Socket
|
7. Fuel pump
8. Filter of the fuel pump
9. Clip
10. Rubber laying
11. Laying
12. The fuel pump in assembly |
The fuel pump – type B
|
1. Fuel level sensor
2. Flange of the fuel pump
3. Sealing ring
4. Fuel filter
5. Fuel pump
6. Pump casing
7. Filter of the fuel pump
8. Clip
|
9. Rubber laying
10. Arm
12. Laying
13. Fuel pump assembled
14. Plate
15. Protection cover
16. Wire of the fuel pump and sensor
17. Cover |
Removal
| PERFORMANCE ORDER |
| 1. Lower pressure in fuel system, and uncover a jellied mouth of the fuel tank. |
| 2. Disconnect a wire of the minus plug of the accumulator. |
| 3. Remove back sitting. |
| 4. Uncover in a floor. |
|
|
| 5. Disconnect a wire and a fuel tube. If connection with flaring is used, disconnect a fuel tube by means of wrenches. If quick disconnect connection is used, unscrew screws (are specified by shooters in the drawing on the right) and remove the protection cover of connection. |
| 6. Unscrew bolts of the block of the fuel pump and fuel level sensor. |
| 7. Get the block from the fuel tank. |
|
8. Disconnect a wire from the pump. |
|
9. Squeeze a clamp of a hose of the pump and remove a clamp. |
|
10. Release the lower part of the pump and disconnect the pump from a hose. |
|
11. To remove the pump of V type, unscrew the screw (it is specified by an arrow) the fuel filter and remove the filter. |
|
12. In turn hook latches on a pump flange. |
|
13. Poddente of a latch also remove the lower arm of the pump. |
|
14. Remove a clamp and disconnect the filter from the pump. If necessary replace the filter. |
|
Installation
Installation is carried out upside-down removals.
