e4035ede

11:11. Decorative panels of bumpers

FRONT BUMPER

PERFORMANCE ORDER
1. Lift the car and establish on supports.
2. Disconnect negative and then the positive plug from the battery and wait not less than 2 minutes.

3. On the Camry models turn off a bolt of fastening of the panel of a bumper and remove plastic percussion caps of fastening of the panel of a bumper.
Prevention

Hook buttons of the central percussion caps the small screw-driver, not to delete buttons as they are pressed in steel futorka.
4. On the Avalon models unscrew two screws and remove percussion caps of fastening of a lattice (arrow).
5. Then disconnect sockets of fog lamps (if are provided) and turn off bolts (shooters) of fastening of the panel of a front bumper.
6. Remove two lower percussion caps.
7. Then unscrew screws (shooters) of fastening of antisplash panels to the lower part of a bumper then access to a bolt of fastening of the panel of a bumper to the lower part of a wing (Avalon model) is provided.
8. Installation is carried out upside-down. At installation previously be convinced that latches from the back of a bumper came into the corresponding brackets on a body. It is expedient to establish a bumper together.

REAR BUMPER

Details of fastening of a rear bumper (Avalon model)

PERFORMANCE ORDER
1. Remove plastic percussion caps (shooters) and unscrew screws of fastening of the lower edge of the panel of a bumper (Camry model).
2. Turn off nuts of fastening of a bumper on corners in a luggage carrier. For access to nuts remove facing.
3. Open a trunk lid and remove percussion caps (shooters) or brackets fixing the top edge of the panel of a bumper. Remove the bumper panel.
Prevention

Hook buttons of the central percussion caps the small screw-driver, not to delete buttons as they are pressed in steel futorka. For removal of bolts from body openings when jamming it is possible to beat out a bolt easy blows of the plastic hammer.
4. Installation is carried out upside-down.