3.2.5. Inlet collector
Removal
| PERFORMANCE ORDER |
|
1. Pit pressure in fuel system and disconnect a wire of the minus plug of the accumulator.
|
|
TOP CAMERA OF THE COLLECTOR
| PERFORMANCE ORDER |
| 2. Merge cooling liquid.
|
|
3. Unscrew two bolts (arrow) and uncover the engine.
|
| 4. Remove the air filter.
|
| 5. Disconnect wires and hoses from a throttle, disconnect a rope of a butterfly valve.
|
|
6. Disconnect a tube of system of recirculation (shooter) of final gases from the camera.
|
|
7. Remove two arms of the camera. |
|
8. Unscrew bolts (A) and twist the nuts (V) fixing the camera to the inlet collector located below and remove the camera.
|
|
LOWER PART OF THE COLLECTOR
| PERFORMANCE ORDER |
| 2. Disconnect wires from fuel injectors.
|
|
3. Disconnect a hose of a heater (A) and a hose of air supply (V) from a collector disconnect a fuel hose from the fuel highway. |
|
4. Unscrew bolts and twist nuts (arrow), remove the lower section of a collector – figures specified the sequence of tightening of bolts and nuts.
|
|
5. Under the lower part of a collector the hose of cooling liquid (shooter) is located. If you removed an inlet collector, is strongly recommended to replace an old hose with new.
|
|
Installation
| PERFORMANCE ORDER |
| 1. Carefully clean and wipe with acetone the joined surfaces of a collector and heads.
|
| 2. Establish new laying and establish the lower section of a collector and tighten bolts till the required inhaling moment.
|
| 3. Establish the remained details.
|
|
