| 1. Remove a cowl. |
| 2. Lower pressure in fuel system. |
| 3. Disconnect a wire of the minus plug of the accumulator. |
| 4. Remove the accumulator and the shelf of the accumulator. |
|
5. If the car is equipped with system a cruise control disconnect a wire from the block of the working mechanism of system (it is specified by an arrow) and remove the block. |
| 6. Remove a starter. |
| 7. Uncover a jellied mouth of the fuel tank and disconnect the fuel tubes connecting the engine to a body. |
|
8. Disconnect tubes (are specified by shooters) a radiator of transmission liquid from the transmission. |
| 9. Disconnect a wire from the switch of system of blocking of the lever of gear shifting. |
| 10. Disconnect a wire from the speed sensor. |
| 11. Disconnect ropes from the lever mechanism of a butterfly valve. |
|
12. Disconnect all hoses and wires from the transmission (the bolt of a wire of grounding is specified by an arrow). Mark the ends of all disconnected hoses and wires not to mix them in installation time. |
| 13. Remove the cooling fans. Merge cooling liquid, remove a radiator and all hoses of the cooling system and a heating system. |
| 14. Disconnect a gear shifting lever rope from the transmission. |
| 15. Weaken bolts of forward wheels, lift the car and fix it on support. Fix the engine on the elevator. Remove forward wheels. |
| 16. Remove an arm of a final collector. |
| 17. Remove forward section of an exhaust pipe. |
| 18. Remove protective guards. |
| 19. Merge transmission liquid. |
| 20. Remove half shafts. |
| 21. Unscrew bolts of a forward support of the engine. |
| 22. Twist nuts of the left support of the transmission. |
| 23. Remove a back support of the engine. |
| 24. In the models equipped with steering transfer with the amplifier disconnect steering transfer from a suspension bracket. |
| 25. Unscrew four bolts of an arm of the stabilizer of stability. |
| 26. Tie up steering transfer to a body and unscrew bolts. Steering transfer should not prevent removal of the transmission. |
|
27. Unscrew suspension bracket cross-piece bolts. Removing a cross-piece, do not forget to make adjusting tags. |
| 28. Establish a jack under the transmission. |
| 29. Remove stiffening ribs from the left and right parties of the transmission. |
|
30. Unscrew bolts (are specified by shooters) hydrotransformer covers. |
|
31. Unscrew the bolts fixing the hydrotransformer to a drive plate. |
|
32. Unscrew the bolts fixing the top part of a casing of the transmission to the engine. |
|
33. Unscrew the bolts fixing the lower part of a casing of the transmission to the engine. |
| 34. Disconnect the transmission from the engine and accurately lower it. |
