10:12. Vacuum amplifier of brakes
Amplifier of brakes
|
1. Main cylinder
2. Hose
3. Laying
4. Fork axis
5. Fork
|
6. Forelock
7. Vacuum amplifier
8. Laying
9. A splitter on ABS system brakes |
Check of operation of the vacuum amplifier
| PERFORMANCE ORDER |
| 1. Press several times a brake pedal on the idle engine. The pedal course by each pressing should not change. |
| 2. Press a pedal and start the engine, – on the serviceable amplifier the pedal of a brake has to be displaced a little forward. |
|
Tightness check
| PERFORMANCE ORDER |
| 1. Start the engine, 1–2 min. later stop. Slowly press a pedal several times. On the serviceable amplifier the pedal course with each pressing has to decrease gradually. |
| 2. Start the engine and press a pedal. Holding a pedal of pressed, stop the engine, – during 30 sec. after a stop the provision of a pedal should not change. |
|
If the amplifier is faulty, then he will lie down to replacement, repair of the unit is impossible even in the conditions of car service.
Removal
| PERFORMANCE ORDER |
| 1. Remove the main cylinder (see subsection 10.9.). |
| 2. Remove a tank for catching of vapors of gasoline (see subsection 7.2.20.). |
| 3. Remove the air filter (see subsection 6.11.). |
| 4. Carefully disconnect a vacuum hose from the amplifier. |
| 5. Working in salon, remove a casing of a steering column (see subsection 11.24.). |
| 6. Having illuminated a lamp, find a fork of a pusher of the vacuum amplifier in the place of fastening on a brake pedal. Rasshplintuyte also get a fork axis. |
| 7. Turn off four nuts of fastening of the amplifier of brakes to a partition of a motor compartment. |
| 8. Give the amplifier and remove when hairpins leave openings in a partition. |
|
Installation
Installation is made in the sequence, the return to removal.
If the new unit is installed, then adjust a gap between a pusher of the main cylinder of a brake and a pusher of the amplifier. For this purpose execute the following.
| PERFORMANCE ORDER |
|
1. Between pushers of the vacuum amplifier and main cylinder of a gap should not be. If the gap nonzero, then increases the brake pedal course. If on the contrary, the pusher of the amplifier rests against a pusher of the cylinder, then wheels can not rastormazhivatsya. |
|
2. Measure a pusher vystupaniye over laying on the case of the amplifier. It is the size A. |
|
3. Measure distance from an end face of the main cylinder to the flange plane. It is the size B. |
|
4. Measure distance from an end face of the main cylinder to the bottom of dredging of the piston. It is the size C. |
| 6. The gap between a pusher and the piston is equal (In – C) – And yes 0 has to be equal. If necessary adjust a vystupaniye of a pusher of the vacuum amplifier. |
|
7. For adjustment of a pusher squeeze a pusher for a neck with a nakatka and rotating a tip of a pusher establish such vystupaniye And that the gap was equal In – S. Snova check a gap. If necessary repeat adjustment. |
| 8. Upon termination of install the main cylinder, attach tubes, adjust height of a pedal and a free wheeling. Remove air from a hydraulic actuator. |
|
