Toyota:: Camry XV20:: Stabilizer and plugs of the stabilizer of a back suspension bracket

9.1.10. Stabilizer and plugs of the stabilizer of a back suspension bracket

Removal

PERFORMANCE ORDER

1. Release nuts of a back wheel, lift a back part of the car and remove a wheel.
2. Remove the heat-insulating guard of an exhaust pipe.
	3. Disconnect from a draft stabilizer bar, having turned off nuts. At a provorachivaniye of a hairpin record it a six-sided key.
	4. Turn off bolts of fastening of collars of plugs of the stabilizer.
5. Remove a stabilizer bar. Remove collars with rubber plugs.
6. Check a condition of plugs If on plugs damages are found (cracks, rubber hardening, strong deformations), then replace plugs. Check a condition of hinges of drafts of the stabilizer (see subsection 9.1.3.).
7. Clear the place of a prileganiye of plugs on a bar of dirt and a rust. Establish all details upside-down. If necessary grease new plugs and collars with culinary vegetable oil. It is forbidden to oil plugs at assembly on an oil basis or brake fluid in order to avoid a premature exit of plugs out of operation.

Installation

The stabilizer is installed upside-down.