9.1.14. Nave and bearing of a back wheel
Details of a nave of a back wheel with bearing knot
|
1. Cylinder
2. Brake disk
3. A nave of a back wheel with the bearing
|
4. Sealing ring of a nave
5. Brake drum |
Removal
Prevention
Nave of a back wheel with the bearing are not subject to repair and change as uniform knot.
| PERFORMANCE ORDER |
| 1. Lift a back part of the car and establish on supports. Remove a back wheel. |
| 2. Remove a drum or a disk of a brake (see subsection 10.6.). |
|
|
3. Turn off 4 bolts of fastening of the case of a nave to a suspension bracket arm through openings in a nave flange. For access to bolts the flange needs to be turned. |
| 4. Remove a nave assembled with the bearing. |
| 5. Remove a sealing ring of a nave. |
|
Installation
| PERFORMANCE ORDER |
| 1. Establish a nave and combine openings in the nave case with openings under bolts in a brake board. Wrap bolts. At installation of bolts in carving openings it is convenient to use a magnet. Tighten bolts with the set moment.
|
| 2. Install the reel (or a disk) brakes, a support and a wheel. Establish a wheel and lower the car.
|
|
