9.1.15. Arm of a back suspension bracket
Arm of a back suspension bracket
|
1. Arm
2. Brake cylinder
3. Nave
4. Disk
|
5. Sealant
6. Drum
7. The speed sensor (on the cars equipped with ABS system) |
Removal
| PERFORMANCE ORDER |
| 1. Lift a back part of the car and establish on supports. Remove a back wheel.
|
| 2. Remove a drum or a disk of a brake assembled with a support. On cars with back drum brakes disconnect a hydraulic actuator tube on the wheel cylinder. On cars with back disk brakes do not disconnect a hose from a support.
|
| 3. On cars with back disk brakes release and turn out a bolt of fastening of a flexible hose to a rack.
|
| 4. Remove a back nave with the bearing (see subsection 9.1.14.). |
| 5. On cars with back drum brakes remove a back brake assembled with a brake board from a suspension bracket arm, without disconnecting a hose. On cars with back disk brakes remove a brake board with the mechanism of the parking brake. Fix the removed knots on a rack spring.
|
| 6. On the cars equipped with ABS system remove the speed sensor. |
|
|
7. Release bolts of fastening of an arm to a rack. |
| 8. Turn off a bolt of fastening of the lever on an arm, remove a nut and washers then finally turn out a bolt of fastening of an arm to a rack.
|
| 9. Supporting an arm, turn off the bolts of fastening of an arm which are released earlier to a rack and separate an arm from a rack.
|
|
Installation
| PERFORMANCE ORDER |
| 1. Check a condition of plugs, existence on them of cracks and wear tracks. Worn-out plugs change in car service.
|
| 2. Establish a suspension bracket arm on a rack arm, wrap bolts by hand.
|
| 3. Establish a bolt of fastening of the lever on an arm, a washer and screw a nut.
|
| 4. A jack raise a suspension bracket arm on height corresponding to driving conditions.
|
| 5. Tighten bolts of fastening of an arm of a suspension bracket to a rack with the set moment.
|
| 6. Attach a longitudinal bar and tighten a bolt with the set moment.
|
| 7. Tighten a bolt and a nut of fastening of the lever.
|
| 8. On cars with back drum brakes fix a hose on a rack.
|
| 9. On the cars equipped with ABS system install the speed sensor.
|
| 10. Establish a brake board, establish a nave and tighten bolts.
|
| 11. On cars with back drum brakes attach a tube to the wheel cylinder.
|
| 12. Install the reel (or a disk) brakes.
|
| 13. Establish a wheel.
|
| 14. Remove air from a hydraulic actuator (see subsection 10.11.). |
| 15. Lower the car and tighten wheel nuts.
|
|
